M3 Machine Start-Up Procedure

M3 Machine Start-Up Procedure

1. Locate the Chill Roll Position, then slowly press IN. After that, press CLOSE.
2. Press the RUN button.
3. On the PB Panel, go to the WATER PUMP menu.
4. Press ON for the following:
   a. Chill Roll Water Pump
   b. Section Cooling Roll Water Pump
   c. Pressure Water Pump
   d. Extruder Water Pump
   After completing these steps, press CLOSE.
5. Go to the Main Line screen, then click RUN.
6. On the Main Line, click THREAD and hold until the indicator turns yellow.
7. Enter the Chill Roll Position menu, then click UP a few times until it reaches the specified limit.
8. Return to the Main Line, then press RUN.
9. In the Casting Section Embossing Nip, press CLOSE on all in the TREATER SECTION.
10. On the Main Line, press SPEED and set the initial speed to 30 km/h as a trial.
11. Go to the SCANNER MONITOR, then press SCAN.
12. On the CORONA MONITOR, press ON with the reading P.1.04 = 1.3.
13. Return to the SCANNER MONITOR, then click AUTO.
14. On the Main Line, press GAUGE. Ensure the speed (SPEED) is correct before pressing GAUGE.
15. For the front part of the machine (WINDER), if it doesn’t move to the left or right, check the Winder Monitor. Click Set Up, then click OSCILLATION, click OFF, and then click ON again.
16. After scanning and the product looks good, the machine is ready to TURN the items.

Comments

Popular posts from this blog

Visi dan Misi serta Schedule PW IPM Sulsel Periode 2014 - 2016

Orang yang dicintai Allah SWT

... KISAH MENGHARUKAN, KETULUSAN CINTA SEORANG SUAMI ...